Class Central is learner-supported. When you buy through links on our site, we may earn an affiliate commission.

Pluralsight

Onshape Essentials: Revolves, Sweeps, and Lofts

via Pluralsight

Overview

Save Big on Coursera Plus. 7,000+ courses at $160 off. Limited Time Only!
Creating non-geometric shapes in CAD can be simple. This course will show you how to use the revolve, sweep, and loft features in the CAD software Onshape through building a multi-part electrical controller. Required Software: Onshape.

Knowing how to construct non-geometric, manufacturable shapes in CAD is essential since not all designs are rectangular boxes. This course, Onshape Essentials: Revolves, Sweeps, and Lofts, will teach you how to create shapes in Onshape that can't be bound by four corners. The Revolve, Sweep, and Loft features are powerful tools used to construct these non-geometric shapes, and you'll learn to use them here. Through this course you will also build a multi-part electrical controller that has complex wire routings and transitions. Finally, you will construct intricate features combining the skills learned in each module. In the end, your knowledge gained from this course will allow you to be a more accomplished and valued CAD designer. Required Software: Onshape.

Syllabus

  • Course Overview 1min
  • Introduction to Sweeps, Revolves, and Lofts 4mins
  • Modeling Using Revolves 25mins
  • Modeling Using Sweeps 30mins
  • Modeling Using Lofts 38mins
  • Conclusion 3mins

Taught by

Jason Durfee

Reviews

Start your review of Onshape Essentials: Revolves, Sweeps, and Lofts

Never Stop Learning.

Get personalized course recommendations, track subjects and courses with reminders, and more.

Someone learning on their laptop while sitting on the floor.