Class Central is learner-supported. When you buy through links on our site, we may earn an affiliate commission.

Pluralsight

Fusion 360 Essentials - Using Intermediate Features

via Pluralsight

Overview

In this course, you will create a model of a teapot in Fusion 360. This will be done using 2D Sketches, in combination with Loft, Sweep, Revolve, Extrude, and Pipe. Software required: Autodesk Fusion 360.

In this course, Fusion 360 Essentials - Using Intermediate Features, you will create a model of a teapot with complex and organic features. The teapot was chosen because it is a recognizable object for designers, makers, and artists. The foundation of the design will be drawn into Fusion 360 with the help of 2D geometry. You will then get to transform this 2D geometry into 3D. You will get to use the following Fusion 360 functions: Loft, Sweep, Revolve, Extrude, and Pipe. When you're finished with this course, you will have used 2D curves to create 3D geometry that is fully constrained with great dimension accuracy. Software required: Autodesk Fusion 360.

Syllabus

  • Course Overview 1min
  • 3D Modeling a Teapot with Time Saving Features 37mins
  • Cleaning Up the Teapot and Adding Details 15mins

Taught by

Kevin Koekkoek

Reviews

4.6 rating at Pluralsight based on 11 ratings

Start your review of Fusion 360 Essentials - Using Intermediate Features

Never Stop Learning.

Get personalized course recommendations, track subjects and courses with reminders, and more.

Someone learning on their laptop while sitting on the floor.