This course is designed to provide an integrated introductory treatment of airplane performance with flavor of aircraft design and flight testing. INTENDED AUDIENCE : UG/PG of B.Tech/BE in any discipline of engineering PREREQUISITES :NILINDUSTRY SUPPORT :DRDO, HAL, Boeing, Airbus, Bell, McDonnell Douglas, UAV Factory, Lockheed Martin
Introduction to Airplane Performance
Indian Institute of Technology Kanpur and NPTEL via Swayam
-
124
-
- Write review
Overview
Syllabus
Week 1: General Introduction: Airplane Performance Characteristics, George Cayley: Concept of Lift and Drag, Introduction to airplane and its components, Hansa 3 Aircraft and its Primary Systems, Concept of Lift: Aerofoil, Wing, and Complete Aircraft, Drag PolarWeek 2: Revision, Standard Atmosphere: Description and Modelling, Measuring Instruments: Altimeter, Airspeed Indicator, Equations of Motion: Static Performance, Thrust Required, Power Required: Cruise, Excess Thrust and Power: Climb Angle and Rate of ClimbWeek 3: Review, Thrust Required: A Closer Look, Modelling of CL: Dimensional Analysis, A Closer Look: Point Mass Model, Dimensional Analysis, Estimation of Drag Polar Through Flight Test, Estimation of Rate of ClimbWeek 4: Revision, Range and Endurance, Range and Endurance(Continued), Gliding Flight, Accelerated Flight, V-n DiagramWeek 5: Revision, V stall: Cruise and Manoeuvre, Flaps: High Lift Devices to Reduce Take off / Landing Distance, Take off: Warm-up Lecture, Take off Performance, Take off Performance (Continued)Week 6: Revision, Landing Performance, Landing Performance (Continued), Challenges in Take-off and Landing: Single and Twin Engines, Introduction to Static Stability, Positioning of Centre of Pressure for Static StabilityWeek 7: Revision, Stability and Control: Designer's Perspective, Stability and Control: Designer's Perspective (Continued), Longitudinal Control: Elevator, Stability: Wing and Tail Contribution, Stability: Wing and Tail Contribution (Continued)Week 8: Control: Elevator, Control: del_E Required, Control: del_E Required (continued), Design Basics: Wing Loading & Thrust Loading,Design Basics: Sweep & Dihedral, Revision
Taught by
A K Ghosh