Replacing Damaged Hydraulic Cylinder Rod for Caterpillar D10 Bulldozer - Part 2
Cutting Edge Engineering Australia via YouTube
Overview
Syllabus
Intro
SETUP TOOL HOLDER AND WNGA CERAMIC INSERT
NOW USING WNMG CARBIDE INSERT
FINAL PASS FOR TURNING DOWN OUTER DIAMETER
MACHINING END TO SPEC FOR THREAD
CHANGE TO GROOVING TOOL
MACHINING RELIEF GROOVE TO HELP AVOID CRACKING OF ROO
CHANGE TO CERAMIC INSERT FOR CHAMFER ON INDUCTION LAYER
TOOL CHANGE TO SNMG FOR CHAMFER
TOOL CHANGE TO THREADING INSERT
SET SPINDLE SPEED TO 24@RPM
DRILL CENTRE HOLE
CHANGE INSERT TO WNMG CARBIDE
4MM DEPTH OF CUT
USING 25MM U-ORILL
ORILL HOLE FOR ROD EYE SPIGOT
MACHINING BEVEL FOR WELO PREP
BAD INSERT TIP
TOOL CHANGE TO CUTE BORING BAR
MACHINING DOWN WELD AS PER CUSTOMER REQUEST
Taught by
Cutting Edge Engineering Australia