Explore a comprehensive 29-minute video tutorial on building a 10G OpenWRT system using the Emulex OneConnect OCe14102 Dual SFP+ Adapter and QSFPTEK SFP+ Transceiver. Learn about hardware setup, OpenWRT firmware building with kmod-b2net package, initial configuration, and performance testing. Discover how to install and configure the adapter, connect SFP+ transceivers, and conduct throughput tests using OpenSpeedTest and iperf3. Gain insights into power consumption, bridging mode configuration, and comparative performance with other network adapters. Follow along as the tutorial covers everything from hardware overview to detailed throughput analysis in both routing and bridging modes.
OpenWRT with Emulex OneConnect OCe14102 Dual SFP+ Adapter - Setup and Performance Testing
Overview
Syllabus
- Build Introduction & Hardware Overview
- Connect/ Disconnect SFP+ Transceiver to SFP+ Adapter with Fiber cable
- Install the Emulex OneConnect OCe14102 on the Zimaboard
- Build OpenWRT x86 with kmod-b2net
- Boot up OpenWRT x86 on the Zimaboard & Initial Setup
- Connect DAC & Fiber cable to the Emulex OneConnect OCe14102
- Install LuCI & Web UI Overview
- WAN to LAN Throughput - OpenSpeedTest
- WAN to LAN Throughput - OpenSpeedTest SW Offloading
- WAN to LAN Throughput - iperf3 SW Offloading
- WAN to LAN Throughput - iperf3 SW Offloading - Single
- WAN to LAN Throughput - Power Consumption
- Change the configuration to Bridge mode
- Bridging Throughput Test - OpenSpeedTest
- Bridging Throughput Test - iperf3
Taught by
Van Tech Corner
Related Courses
-
OpenWRT Router Build with Mellanox ConnectX-3 10GbE SFP+ Network Adapter and Zimaboard
-
OpenWRT - Realtek RTL8125B 2.5GbE Network Adapter Overview and Testing
-
Fast Rhino R68s - Firmware Upgrade and WAN to LAN Throughput Testing
-
Replacing ISP ONT/ONU with PON Stick - GPON Module Configuration on OpenWRT
-
OpenWRT with Intel X540-T2 10GbE RJ45 Network Adapter - Installation and Performance Test
-
NanoPi R6S - Wireguard and OpenVPN Throughput Test
