Explore the process of upgrading a Sovol SV08 3D printer with a StealthChanger toolchanger mod in this comprehensive video tutorial. Learn how to convert to mainline Klipper firmware and improve the toolchanger wiring using a Bird's Nest Klipper USB hub. Follow step-by-step instructions on backing up configurations, removing the old eMMC, flashing new firmware, and setting up the Birds' Nest USB hub. Gain insights into hardware and software requirements, including the use of SSH clients and flashing tools. Discover how to connect an ST-Link programmer, back up MCU firmware, and flash bootloaders. By the end of this tutorial, acquire the knowledge to enhance your 3D printer's capabilities with improved wiring and updated firmware.
Better Wiring and Mainline Klipper for Budget Sovol SV08 Toolchanger - Part 3
Teaching Tech via YouTube
Overview
Syllabus
Introduction
Sovol Klipper can’t be updated
Understanding the hardware and software required
Backing up Klipper config
Removing the old eMMC
Flashing and prepping the CB1 image
Installing mainline Klipper via KIAUH
Adding back configuration files
Connecting the ST-Link programmer and backing up MCU firmware
Preparing and flashing the MCU bootloader
Building and flashing Klipper to each MCU
Updating to a Birds’ Nest USB hub by Isik’s Tech
Birds’ Nest case and mounting
Birds’ Nest Wiring
Birds’ Nest Klipper config
Conclusion
Taught by
Teaching Tech
