Completed
- Notepad++
Class Central Classrooms beta
YouTube videos curated by Class Central.
Classroom Contents
How to Install Klipper - The Easy Way, Step by Step
Automatically move to the next video in the Classroom when playback concludes
- 1 - Intro
- 2 - Pi and Octopus LEDs, connections, and SD card slots
- 3 - Software used to easily install Klipper
- 4 - A bit about the SD cards
- 5 - Cutting Belts
- 6 - Belting A Complete
- 7 - Raspberry Pi Imager
- 8 - Brief on Angry IP Scanner
- 9 - Brief on WinSCP
- 10 - Brief on PuTTy
- 11 - Notepad++
- 12 - MainsailOS is on the SD card and ready
- 13 - SD card into Raspberry Pi to Load MainsailOS
- 14 - CMD to run a ping to the Pi and see it come up
- 15 - Mainsail is running! Web GUI up
- 16 - Angry IP Scanner in use to find an IP address of a device on the network
- 17 - SSH in to the Pi using PuTTY
- 18 - Makemenu on the Pi
- 19 - Makemenu settings for Octopus MCU
- 20 - Compile Klipper Firmware
- 21 - Rename the Klipper.bin to firmware.bin
- 22 - WinSCP to transfer the klipper firmware
- 23 - Install Klipper firmware on the Octopus controller
- 24 - printer.config - How to
- 25 - Update serial device in printer.cfg
- 26 - Setting up printer.cfg for your specific printer 300mm
- 27 - MCU Shutdown! This Thermals and such
- 28 - Overview of the Mainsail interface
- 29 - Wrap-up and final thoughts about Klipper and Mainsail
